The Place

When a friend of mine made me a set of Chambers for my outfit, you may have heard of him, Peter Gibson. He told me how I could change the way the Chambers worked? And it involves exhaust rap which I have used with no trouble. To move the power band you need to make the length of of the body longer ...

Thank you Tony. So do I, had a health problem a couple of years ago , I took it to Lyden at the weekend but the brain is not as good as it was. Hope you are well. Richard.

I will be away till next weekend.

Classic Saab lynx 3 cylinder two stroke outfit and all spares for sale. 10.000 pounds.
Richard Holmes. 01255 818017

It's Jan Herberts old outfit, it used to go very well.

When I started to use yoko's a few years ago the cost was a big consideration, Im going back a few years when yoko's were first used in the CRMC the cost of a yoko was £33.00 and the cost of a Dunlop cr65 was £115.00 and they lasted a lot longer

look on steve's bikes for sale under classics, check the front yoko on the b.m.w and tell me that worn tyre is not over 5.5 inches

The tyre looks on a narrow rim or not on a rim. Plus you cannot see were the rule is on the tyre, as I said the rim size will make a big difference, they are just to wide. Also as the tyre wears down the tread on the road will increase, They maybe just a small bit bigger but they are outside the ...

Eddy you have been changing gear when you should be pulling in the clutch

I always thought boxing boots best as they went with the leathers

Hi Eddy, No don't know, but I think it the rim size will make a big difference. If it is on a 6 inch the the tread on the road will be less because the tread will not be flat to the ground, but when the tyre is stressed it will pull this onto the ground. iF its on a rim that stretches the walls of ...

Here is the yoko spec for ao48
175/60/13, rim size 5-6 inches,overall dimensions width180mm.7.1 inches, rolling circum1634.
185/60/13 rim size 5-6.5 inches overall dim width188mm. 7.4 inches rolling circum1677.
So as you can see they are to wide and the gauge has been in the club since Alan Bedfords ...

Sean I can see a problem with the engine it won't go round corners, it was made to go in a staight line

I have a plan, a cunning plan, if I lower the exhaust port and vent it through the side of the piston and then put a spark plug in the crank case with a 4 valve head on the top, I will have a one stroke engine. now were's Ian

If I can keep the look of the engine so you cannot see the changes, can I use a 4 valve head on my outfit, because I feel I am missing out and lack an advantage. I think with a bit hammering and welding I think I could make it work?