Krober Rev counter wiring

Simon Smith · Unread post by **Simon Smith** » Mon Mar 14, 2011 2:24 pm

Does anybody know how a Krober rev counter should be wired?

lang · Unread post by **lang** » Mon Mar 14, 2011 4:28 pm

A Krober must always be mounted 25mm away from all adjacent parts. It is always connected to the contact breaker by the lead supplied with the rev counter on terminal 1. The mounting bracket of the rev counter which is connected to terminal 4 of the rev counter by a short lead must make electrical contact with the earth of the motorcycle. If used with electronic ignition the main lead is connected to the CB side of the coil.

Hope this helps,
Howard.

Simon Smith · Unread post by **Simon Smith** » Wed Mar 16, 2011 9:35 pm

Thanks Howard.

All sorted now. Except the engine won't start but that's another issue.

Eddy Wright · Unread post by **Eddy Wright** » Wed Mar 16, 2011 11:19 pm

Ignition Timing ?

Simon Smith · Unread post by **Simon Smith** » Thu Mar 17, 2011 7:29 am

I set it static and with a strobe on rollers. There is a spark and fuel. Just won't go. It was fine two days ago.

Eddy Wright · Unread post by **Eddy Wright** » Thu Mar 17, 2011 2:51 pm

What ignition is fitted ?

Simon Smith · Unread post by **Simon Smith** » Thu Mar 17, 2011 3:59 pm

It was a points, condenser type.

I have now fitted the one off our old engine.

Does anyone know where the two wires should go?

Eddy Wright · Unread post by **Eddy Wright** » Thu Mar 17, 2011 5:01 pm

Where is the Condenser ? If its not in the distributor, then one wire goes to the coil and the other to the condenser.

Simon Smith · Unread post by **Simon Smith** » Thu Mar 17, 2011 10:22 pm

Gone back to points dizzy. Still not running. Suspect fuel contamination.

I'll flush the system tomorrow and try new fuel.

richard · Unread post by **richard** » Sun Mar 20, 2011 3:15 pm

Hi, the distibutor you have there is electronic it has no points and condencer and the two wires go to the control box.

Simon Smith · Unread post by **Simon Smith** » Mon Mar 21, 2011 4:27 pm

Hi Richard,

I need to know the make. It never had a control box.

I've fitted a brand new Lumenition which didn't work either. Dave Johnson and I fitted a new loom and a spare Lumenition and it is all working now.

What a pain this has been. Must of had an intermittent short in the loom.

Triplebrew2 · Unread post by **Triplebrew2** » Tue Mar 22, 2011 4:19 pm

Glad u got it all sorted Simon, best of luck for the weekend.

The Place

Krober Rev counter wiring

Krober Rev counter wiring

Re: Krober Rev counter wiring

Re: Krober Rev counter wiring

Re: Krober Rev counter wiring

Re: Krober Rev counter wiring

Re: Krober Rev counter wiring

Re: Krober Rev counter wiring

Re: Krober Rev counter wiring

Re: Krober Rev counter wiring

Re: Krober Rev counter wiring

Re: Krober Rev counter wiring

Re: Krober Rev counter wiring