Hi - anyone have a clue what the disks are on a 350 Shelbourne ?
I would guess it's a car disk - but not sure - would help if I knew what car it came off - somebody told me years ago that the rear wheel bearing / hub setup was off a volkswagen ? (probably not relevant anyway)
Many Thanks !
Shelbourne Disks ?
-
G JONES
- Lapping the Tail Enders
- Posts: 380
- Joined: Wed Jun 14, 2006 8:28 pm
- D/P/T/M/S: D
- Full Name: Gordon Jones
- Location: Shropshire
- Contact:
Shelbourne Disks ?
2 strokes are the future...
TZ Parts List
http://tz350.co.uk
Had to laugh at this I heard somewhere... "You can't polish a Turd"
TZ Parts List
http://tz350.co.uk
Had to laugh at this I heard somewhere... "You can't polish a Turd"
-
steve-e
- Site Admin
- Posts: 8823
- Joined: Wed Jun 14, 2006 6:12 pm
- D/P/T/M/S: resting Passenger
- Full Name: Steve English
- Skype contact: steveenglish.com
- Twitter: @steveinmarden
- Location: Marden, Kent
- Contact:
Re: Shelbourne Disks ?
Years back when dad built his mono's he used VW Variant stuff
IF YOU'VE FORGOTTEN YOUR LOGIN EMAIL ME, WE ARE GOING BACK TO BEING LOGGED IN TO READ.
steve@steveenglish.com subject:login and whatever details you remember
steve@steveenglish.com subject:login and whatever details you remember
-
G JONES
- Lapping the Tail Enders
- Posts: 380
- Joined: Wed Jun 14, 2006 8:28 pm
- D/P/T/M/S: D
- Full Name: Gordon Jones
- Location: Shropshire
- Contact:
Re: Shelbourne Disks ?
Thanks Steve - I had the VW estate in my head but couldn't think of the name of it - so maybe Shelbourne's the same...steve-e wrote:Years back when dad built his mono's he used VW Variant stuff
Thanks for that - will probably have to hope that showing it to a "Parts Man" at a motor factors will get a "Yea - got one like that off a..." - unless I can find a list somewhere with a few measurements...illi wrote:If you`re after a cheap disc for a wheel with an odd number of holes (i.e. Windle with 5) the cheapest option is a Citroen disc, off the basic AX. Used them a few times - they`re only about £4.50. Less than a fiver, anyway! They`ve got three holes, so it`s easy to drill more for mounting holes combined with lightening ones.
The disk on there is a 4 hole - and is using 2 of the original holes - elongated - plus 4 extra holes to bolt to the shaft..
2 strokes are the future...
TZ Parts List
http://tz350.co.uk
Had to laugh at this I heard somewhere... "You can't polish a Turd"
TZ Parts List
http://tz350.co.uk
Had to laugh at this I heard somewhere... "You can't polish a Turd"
-
craig hauxwell
- One Lap Completed
- Posts: 82
- Joined: Thu May 22, 2008 12:00 am
- D/P/T/M/S: DRIVER
- Full Name: craig hauxwell
- Location: wirral
Re: Shelbourne Disks ?
Gordon the shelbourne discs you want are off a MK2 cortina.once theve been machined to tickness and diameter they will bolt straight on. trust me i have a new set made every 2 years.