Page 1 of 1

Darley Moor Gearing

Posted: Fri Apr 30, 2010 9:14 am
by little chud
Hi all.

what geaaring should we run at Darley? about the same as Cadwell or will it take a tooth less on the back?

cheers

JC :D

Re: Darley Moor Gearing

Posted: Fri Apr 30, 2010 10:49 am
by gatekeeper
i seem to remember 13/42 with my r6 motors

Posted: Mon Jul 19, 2010 1:01 pm
by iomttsean
Any one know what it should be on a honda motor with carbs?

Re: Darley Moor Gearing

Posted: Mon Jul 19, 2010 5:57 pm
by lovingit
cant remember but same as mallory and you wont got far wrong

Re: Gearing

Posted: Wed Jul 21, 2010 9:40 pm
by andystone
iomttsean wrote:Any one know what it should be on a honda motor with carbs?
Unsure mate with your set up, but bare inmind you may be better upping the rear for better acceleration out of the tight bends, and sacrifice a little top end, after all the straight an`t that long & after park corner its a bit of a climb to the esseS. All & all its a good little track.

Re:

Posted: Fri Jul 23, 2010 2:30 pm
by custardchucker
iomttsean wrote:Any one know what it should be on a honda motor with carbs?
Depends if your going to have 1 or 2 people on the bike as the gearing will be different if the passenger platform is empty!!!!!!!! :lol: :lol: :lol: :D :D :lol: :lol: :lol:

Re: Re:

Posted: Tue Jul 27, 2010 5:59 pm
by iomttsean
custardchucker wrote:
iomttsean wrote:Any one know what it should be on a honda motor with carbs?
Depends if your going to have 1 or 2 people on the bike as the gearing will be different if the passenger platform is empty!!!!!!!! :lol: :lol: :lol: :D :D :lol: :lol: :lol:
haha, very true. you have found my secret weapon, get rid of your passenger and it gos a lot faster :)