Who's disk? 81 Fiddaman
Posted: Sat Oct 24, 2015 12:46 am
Anyone know where the ventilated front rotor was sourced for the 81 Fiddaman? It used an automotive Lockheed caliper.
Page 1 of 1
Re: Who's disk? 81 Fiddaman
Posted: Sat Oct 24, 2015 6:37 am
It was I understand a Ford Grenada
Re: Who's disk? 81 Fiddaman
Posted: Sun Oct 25, 2015 12:56 am
Thanks, will follow-up on that.
Re: Who's disk? 81 Fiddaman
Posted: Sun Oct 25, 2015 4:29 pm
Well it's not a Granada rotor. They are 5 bolt from what I can find, and this is 6 bolt. Any other suggestions??RARING TO GO wrote:It was I understand a Ford Grenada
Pics coming
Re: Who's disk? 81 Fiddaman
Posted: Mon Oct 26, 2015 8:42 am
Re: Who's disk? 81 Fiddaman
Posted: Mon Oct 26, 2015 8:52 am
Ford Sierra?
Re: Who's disk? 81 Fiddaman
Posted: Mon Oct 26, 2015 2:10 pm
Lockheed disc from a early
formula 3 car ? try looking on the AP Racing website
formula 3 car ? try looking on the AP Racing website
Re: Who's disk? 81 Fiddaman
Posted: Tue Oct 27, 2015 11:30 am
no luck so far, any other suggestions??
Re: Who's disk? 81 Fiddaman
Posted: Tue Oct 27, 2015 5:31 pm
As far as I know it is a Granada rotor. Forget about the 5 bolt holes, that bit is cut off anyway. The Granada rotor needs to be machined to fit your outfit. The slots and holes in the rotor shown in Steve's pictures are not standard. Early LCR's also used Granada rotors. I used rotors from a Citroen CX on my outfits, the outer diameter was similar to the Granada rotor but on the inside there was a bit more "meat" to play with.
Re: Who's disk? 81 Fiddaman
Posted: Thu Oct 29, 2015 5:07 pm
I think a few lads used ford transit discs to start with, then machined them to suit. hope that helps.
Re: Who's disk? 81 Fiddaman
Posted: Thu Oct 29, 2015 9:10 pm
Thanks for another lead Steve, will check into the Transit rotors.