Looks like it's 20mm, does anyone know pitch? (Can't find my gage)
Nut was so tight, 1000# impact wouldn't break, so had to cut off.
Anyone every had this happen?
lcr front axle question
-
criso
- One Lap Completed
- Posts: 87
- Joined: Mon Aug 16, 2010 6:02 pm
- D/P/T/M/S: Passenger
- Full Name: Sam Christie
- Location: Beverley
Re: lcr front axle question
M20 x 1.5mm Pitch.... Same as M20 Electrical Conduit
-
Team RGM
- Fired Up
- Posts: 38
- Joined: Wed Nov 01, 2006 5:58 pm
- D/P/T/M/S: Driver
- Full Name: Rick Murray
- Location: North Highlands, California
- Contact:
Re: lcr front axle question
Thanks, found local, off to races tomorrow.-
Team RGM
- Fired Up
- Posts: 38
- Joined: Wed Nov 01, 2006 5:58 pm
- D/P/T/M/S: Driver
- Full Name: Rick Murray
- Location: North Highlands, California
- Contact:
Re: lcr front axle question
Races went well, bettered our track time.
On the axle; does anyone know what front axle started as? This is the one that has two bearings.
Need to make/buy new one.
Rick & Tamara
On the axle; does anyone know what front axle started as? This is the one that has two bearings.Need to make/buy new one.
Rick & Tamara