CBR 600 Ignition issue?
-
duncan
- One Lap Completed
- Posts: 82
- Joined: Thu Jul 13, 2006 1:13 pm
- D/P/T/M/S: Driver
- Full Name: Duncan Rogers
- Location: Melbourne Australia
CBR 600 Ignition issue?
We're dynoing a CBR600 & the pipes are glowing red. It's also down a bit on power/torque than we expected. Checking over stuff I noticed the knock sensor is there but no plug for it. Does the ECU back the timing off if there is no sensor found? Tried 2 different ECU's & slight difference only.
-
criso
- One Lap Completed
- Posts: 87
- Joined: Mon Aug 16, 2010 6:02 pm
- D/P/T/M/S: Passenger
- Full Name: Sam Christie
- Location: Beverley
Re: CBR 600 Ignition issue?
If it is a kit ecu, the knock sensor isn't used.
Can you read the ecu to alter the fuelling?
Adam
Can you read the ecu to alter the fuelling?
Adam
-
duncan
- One Lap Completed
- Posts: 82
- Joined: Thu Jul 13, 2006 1:13 pm
- D/P/T/M/S: Driver
- Full Name: Duncan Rogers
- Location: Melbourne Australia
Re: CBR 600 Ignition issue?
It's actually running a bit rich & we're a bit hesitant to lean it off.