Chair Wheel Rims (Windle Style F1)

Kensei · Unread post by **Kensei** » Mon Aug 10, 2015 5:11 pm

Courtesy of a local Numpty (masquerading as a garage) destroying the rim of our F1 chair wheel we need some new rims for a chair wheel.
Can anyone give me a contact number and/or a quote for replacement rims?

little chud · Unread post by **little chud** » Mon Aug 10, 2015 9:14 pm

What width rims do you need mate? I've got a pair on a centre and a lose pair but not sure what width they are. Will try check them tomorrow.

Kensei · Unread post by **Kensei** » Tue Aug 11, 2015 12:00 am

Ill measure them up tomorrow, thanks!

oldbelly · Unread post by **oldbelly** » Tue Aug 11, 2015 4:22 pm

If you have F2 rims the F1 and F2 Windle rims arent the same John . Different bolt holes.

G JONES · Unread post by **G JONES** » Tue Aug 11, 2015 5:05 pm

oldbelly wrote:If you have F2 rims the F1 and F2 Windle rims arent the same John . Different bolt holes.

We are using the "Windle F1 pattern on our bike - forget the hole size - but 18 bolts - I've got a few in various conditions...

lrb1 · Unread post by **lrb1** » Tue Aug 11, 2015 8:23 pm

try dave cheesemond at d&d windle he pressed one out for me about 0 quid i think

Unread post by **steve-e** » Tue Aug 11, 2015 9:40 pm

I'd pay twice that

little chud · Unread post by **little chud** » Wed Aug 12, 2015 11:01 am

I didn't know that Geoff. I'm not sure what they are off, just accumulated them along the way as we tend to

I have a single nut wheel with 20 hole rims. Inner is 45mm and outer is 160mm. Its the type with the outside face of the spokes machined rather than just cast.

I also have 2 rims on their own. inner is 50mm and outer is 225. Both 20 hole and anodised black.

Open to offers on them if they are any good.

cheers.

jc.

stepawley · Unread post by **stepawley** » Fri Aug 14, 2015 6:29 pm

Hi mate I got my wheel rims from image. I took one down to them and they marched them up, hope it helps ste

Kensei · Unread post by **Kensei** » Mon Aug 31, 2015 2:09 pm

Thanks guys, sorry ive been away a bit, John, I'll get my dad to give you a bell.

The Place

Chair Wheel Rims (Windle Style F1)

Chair Wheel Rims (Windle Style F1)

Re: Chair Wheel Rims (Windle Style F1)

Re: Chair Wheel Rims (Windle Style F1)

Re: Chair Wheel Rims (Windle Style F1)

Re: Chair Wheel Rims (Windle Style F1)

Re: Chair Wheel Rims (Windle Style F1)

Re: Chair Wheel Rims (Windle Style F1)

Re: Chair Wheel Rims (Windle Style F1)

Re: Chair Wheel Rims (Windle Style F1)

Re: Chair Wheel Rims (Windle Style F1)