The Place

Courtesy of a local Numpty (masquerading as a garage) destroying the rim of our F1 chair wheel we need some new rims for a chair wheel.
Can anyone give me a contact number and/or a quote for replacement rims?

What width rims do you need mate? I've got a pair on a centre and a lose pair but not sure what width they are. Will try check them tomorrow.

Ill measure them up tomorrow, thanks!

If you have F2 rims the F1 and F2 Windle rims arent the same John . Different bolt holes.

oldbelly wrote:If you have F2 rims the F1 and F2 Windle rims arent the same John . Different bolt holes.

We are using the "Windle F1 pattern on our bike - forget the hole size - but 18 bolts - I've got a few in various conditions...

try dave cheesemond at d&d windle he pressed one out for me about 0 quid i think

I'd pay twice that

I didn't know that Geoff. I'm not sure what they are off, just accumulated them along the way as we tend to

I have a single nut wheel with 20 hole rims. Inner is 45mm and outer is 160mm. Its the type with the outside face of the spokes machined rather than just cast.

I also have 2 rims on their own. inner is 50mm and outer is 225. Both 20 hole and anodised black.

Open to offers on them if they are any good.

cheers.

jc.

Hi mate I got my wheel rims from image. I took one down to them and they marched them up, hope it helps ste

Thanks guys, sorry ive been away a bit, John, I'll get my dad to give you a bell.